[openob-users] Link audio is not clean. How to diagnose/tune/monitor.

Until now, we only planned to use our remote setup to send vocal audio over the link from the "road" end (tx). The music part of the final signal was to be created at the "transmitter" end (rx). Now we have a situation where we think we want to send the complete audio mix from the "road" end (tx). We are noticing pauses / glitches in the audio. What is a good approach to try and "fix" this situation? Some info. Openob link is running on an openvpn tunnel. "transmitter" end (rx): tun0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST> mtu 1500 inet 10.8.0.1 netmask 255.255.255.255 destination 10.8.0.2 /usr/local/bin/openob 10.8.0.1 test-rx-node test-link rx -a jack -jn openob -aj -jp jack_mixer:ICh2 "road" end (tx): tun0: flags=4305<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST> mtu 1500 inet 10.8.0.6 netmask 255.255.255.255 destination 10.8.0.5 /usr/local/bin/openob 10.8.0.1 test-tx-node test-link tx -a alsa -d hw:0 10.8.0.1 -e opus -b128 --framesize 60 -j 80 --fec -l 5 The above line is my latest effort. Started with this: /usr/local/bin/openob 10.8.0.1 test-tx-node test-link tx -a alsa -d hw:0 10.8.0.1 The loss on the link just observed with mtr was under 1%. Does it hurt to set it higher than observed? (I am not concerned with delay / latency on the link if I can get a better sound out the far end. (Within reason. I don't want to burn CDs and drive to the far end... ~;-) all the best, drew Is there any other info I should supply? -- Enjoy the *Paradise Island Cam* playing *Bahamian Or Nuttin* - https://www.paradiseislandcam.com/